As prices for IP cameras continue to drop and the quality continues to rise, there is an increase in the number of IP camera installations in many types of facilities which already have installed coax. ETS now has a way to utilize the existing coax cable by installing a pair of low cost ETS IP Camera Baluns (EIP-XX Series).a technology unique to ETS.
Using installed coax with ETS IP Camera Baluns can be used as a permanent installation solution or as a stop-gap measure until later upgrades are made. One run of coax cable replaces two pair UTP with improved NEXT (near-end crosstalk) over the 802.3 specification.
Most existing installations for CCTV cameras use 75 ohm RG59 coax or similar cable.
A variety of configurations are available to meet your specific IP camera connectivity requirements.Features:
- Low cost speedy installation using legacy cable
- Exceeds 802.3 10BaseT NEXT specification, isolating the receiver from the transmitted signal
- Passive unit (no power required)
- Run up to 150 meters on coax
- Impedance matched
- Rugged compact case
- Made in USA
- 100% tested